Soulmask
Setup cluster​
If you're using a non-clustered server, you must follow these instructions to migrate your saves.
In order to cluster your Soulmask servers, it is best to use 2 separate config templates. One for your master server, one for your slave servers.
When your servers are password-protected, all servers in the cluster must use the same password.
Region settings​
Add -gamedistindex=3 to your config template's END section and change it to the region settings you want to use:
0: Test (events allowed any time)
1: Asia
2: North America
3: Europe
4: Mainland China
5: South America
6: Oceania
7: Africa
Enable cluster mode​
Search the GameXishu.json file on your config templates for KaiQiKuaFu and make sure it is set to 1 like so: "KaiQiKuaFu": 1.
Master server​
The master server is where the account data is stored.
The following settings must be present on the END section for your master server config template:
-serverid={container.id} -mainserverport={gameserver.raw_port}
Slave servers​
Visit the Connect page for your master server, after it was succesfully installed.
Find the Raw UDP port. This will be the mainserverport that your slave servers need to connect with.
The following settings must be present on the END section for your slave server config template:
-serverid={container.id} -clientserverconnect=xxx.xxx.xxx.xxx:pppp
Replace xxx.xxx.xxx.xxx with the IP address of your master server and pppp with the Raw UDP port you found on the Connect page.